Larsen LED light kits that will fit the 60 series JD. Option 1 is for tractors using the rectangular Hi-Lo light in the front fender, option 2 is for tractors using the round PAR-36 Hi-Lo light (4.5" round) in the front fender. (Rare) Next the 8x60/70 series kits.
The lights included in the kit are 4 x front grill lights, 2 x Front fender Hi-Lo lights, 4 x top fender lights front and rear including male and female connectors, 2 x rear top cab lights.
The LED Par-36 use female spade terminals to connect to the wires (included). 12-24 volt. 3-year warranty. The high output Par-36 is 1700 lumen effective / 2200 raw. We work with REAL lumen & amp draw, not a calculated number.
2 Hi-Lo (wire on high) and 2 trapezoid lights for the front grill lights, 2 flood and 2 trapezoid for the top roof lights & 2 flood and 2 trap for the rear fender lights. . (1400 lumen each bulb)
2 Hi-Lo and 2 trapezoid lights for the front grill lights, 2 flood and 2 trapezoid for the top roof lights & 2 flood and 2 trapezoid for the rear fender lights. High Output Par-36 in this kit! (1700 lumen each)
High power PAR-36 size replacement LED light for the old style sealed beam halogen light. 6 x 5 watt CREE LED chips. Actual power use is around 22 watt, effective lumen around 1700. 60° Flood Beam
High power PAR-36 size replacement LED light for the old style sealed beam halogen light. 6 x 5 watt CREE LED chips. Actual power use is around 22 watt, effective lumen around 1700 Hi-Lo Beam, 800 low beam
High power PAR-36 size replacement LED light for the old style sealed beam halogen light. 6 x 5 watt CREE LED chips. Actual power use is around 22 watt, effective lumen around 1700. 40° trapezoid beam
LED-660 is a 4x6 style LED work light. 6 CREE LED's at 10 watt each, 4100 lumens, 5000k, and only 3.6 amp use. Select the light beam type, then select the bracket you need for your application. Comes with a 7" adapter cable that fits 9005 or H11 connectors. You can find more adapter cables at the bottom of this page.
If you replace your stock flashers with LED flashers, you might need a new flasher relay or a set of resistors in order for the flashers to flash normally.
If you replace your stock flashers with LED flashers, you might need a set of resistors or a LED flasher relay in order for the flashers to flash normally. If possible use the LED flasher relay instead of the resistors. Find it further down on this page.